Independent appliance repair
What changed? Start with the symptom.
A sound, a leak, a cycle that stops. Choose your appliance and follow the observation.

Start from what you notice.
Dishwasher not draining
The DBI786 manual traces water left above the filters to four things you can check yourself: clogged or loose filters, debris in the drain pump, a missing drain pump stop, and a kinked or blocked drain hose.
Dishwasher leaking water
Close the water supply valve before anything else, then look at the display.
Dishwasher won’t start
On ASKO dishwashers like the DBI786 and DBI675, you press Start and then close the door within four seconds.
Dishwasher not cleaning well
Start with the spray arms and filters.
Detergent left in the dispenser
The DBI786 manual names two causes for detergent left in the cup: the compartment was damp when you filled it, or a dish stopped the lid from opening.
Dishwasher water not heating
A lukewarm finish isn’t proof the heater has failed.
Washer not spinning
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose.
Washer won’t drain
First rule out a setting: Rinse and hold leaves the laundry sitting in the last rinse on purpose.
Washer leaking water
Stop the washer, switch it off and unplug it, then find where the water starts.
Washer making unusual noise
A new washer noise is easier to pin down once you know when it happens: filling, washing, draining or spinning.
Washer door seal leaking
Water at the door doesn’t always mean a bad seal.
Washer making loud noises
The WM86L manual traces loud rattling and shaking to how the washer stands and how the load sits.
Washer smells bad
On the ASKO WM86L, smells come from detergent, softener and fabric residue in the pump filter, or from bacteria and mold in the drum.
Stains remain after washing
If stains survive the wash, the WM86L manual points first to a program that wasn’t strong enough for the soil.
Washer won’t start
Close the door firmly until it clicks, then press Start/Pause.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first.
Dryer takes too long
Before you book, check three things: that the washer spun the clothes well, that the load suits the program you picked, and that both lint filters are clean.
Dryer controls won’t respond
Check the lock first.
Dryer drum won’t turn
A still drum doesn’t mean a broken belt.
Dryer making loud noises
Some sounds are normal on a heat-pump dryer like the ASKO T5HXL: compressor hum, pumping as water moves to the tank, and buttons or zippers rattling.
A little clarity, right here.
A code on the display.
A place to start.
Turn a dishwasher message into plain English. Find out what it means before you book.
All dishwasher error codesF11 means your ASKO dishwasher couldn’t pump the water out. Clean the coarse and fine filters first, then clear the drain pump and check the drain hose. All three are owner jobs in the manual, done with the power off.
Read the F11 checks10 researched dishwasher codes. Meanings vary by model; check your manual.
There’s no code on the display. Where do I start?
Start here. Pick your appliance, then the problem that sounds closest: a leak, water left inside, no heat, loud noises or a machine that won’t start. There are 26 problem pages across dishwashers, washers, dryers, ovens and cooktops.
What if I’m seeing more than one problem?
Write down what happened first. A cycle that stopped before water pooled points somewhere different from a leak that came first. That order helps the technician narrow it down faster.
Will the problem page tell me which part has failed?
No, and nobody can say for sure from a symptom alone. Several different parts can cause the same leak or the same cold drum. The page shows what you can safely check, and the technician confirms the cause at your home.
When should I stop and call instead?
Stop if water is leaking, if you smell burning or if the next step means removing a panel. Stop, too, when the checks on the page don’t change anything. Book a visit and tell us what you’ve already tried.
Code / symptom / part / service
Connect the message to the next step.
Dishwasher not draining
The DBI786 manual traces water left above the filters to four things you can check yourself: clogged or loose filters, debris in the drain pump, a missing drain pump stop, and a kinked or blocked drain hose. Unplug the dishwasher before you start.
Dishwasher repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.




