Start from the symptom
ASKO dryer takes too long.
Before you book, check three things: that the washer spun the clothes well, that the load suits the program you picked, and that both lint filters are clean. Each one can stretch a drying cycle on an ASKO dryer.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Spin harder in the washer
Laundry that goes in heavy and wet takes much longer to dry. ASKO recommends a washer spin of at least 800 rpm before you move the load across.
- 2
Match the load to the program
Sort by fabric and thickness so towels and light shirts dry separately. Too much or too little laundry for the program also slows drying.
- 3
Clean the filters and note the display
Clean the door filter and the lower filter, then write down any message the display shows. Note whether the dryer stops on its own or keeps running.
Systems a technician may investigate.
The glossary pictures show each part type with dishwasher examples. ASKO’s T5HXL dryers heat the air with a heat pump rather than an element, so the technician works out any replacement part from your exact model.
If the display adds a code.
Keep the exact message.
This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.
See the research statusRead the related care guide.

Dryer not drying? Start with the filters.
When an ASKO heat-pump dryer stops heating or drying, the usual causes are clogged filters, a room that is too warm, cold or cramped, the wrong program, or laundry that wasn't spun enough. Here's how to check each one.

Drying taking longer? Check both lint filters.
Clean the door lint filter after every load, and clean the lower lint filter, its foam filter and the housing at least every 10 cycles, brushing the heat exchanger fins gently if dust has built up.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if drying still takes too long after you’ve cleaned the filters and adjusted the load and spin. Don’t remove panels to look inside.
Arrange a diagnosticSources and model boundaries.
These references support the Dryer takes too long guidance. Read the manual that matches your model.
- ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use
Use the instructions for your exact model. See how we research these pages.
Why do sheets come out wet in the middle?
Bedding tends to roll into large balls in the drum. Fasten buttons and zippers before drying and use a program meant for bedding; afterward, loosen the bundle and finish with a Time program.
Why is some of the load dry and some still damp?
Mixed fabrics dry at different speeds. ASKO suggests sorting by type, thickness and amount to match the program.
Does a full drum dry faster?
Not always. ASKO lists both too much and too little laundry as reasons for poor drying, so fill the drum to suit the program rather than to the top.
What should I tell the technician?
How long a typical load takes now compared with before, the program you use, and whether the dryer finishes on its own or keeps going.
Code / symptom / part / service
Connect the message to the next step.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.
Dryer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.
