Start from the symptom
ASKO dryer drum won’t turn.
A still drum doesn’t mean a broken belt. On ASKO T5HXL dryers, the drum stops when the door isn’t fully shut, the condensate tank is full, the program wasn’t started correctly, or a delayed start is set. Check those four first.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Close the door firmly
Open and close the door again. If the display says “Please close the door to continue”, the dryer doesn’t see it as shut; check that laundry or a loose lint filter isn’t in the way.
- 2
Empty the condensate tank
On condenser and heat-pump dryers, a full tank stops the drum and the display asks you to empty it. Empty the tank, slide it back in and restart.
- 3
Cancel a delayed start
If Delay start is set, the dryer is waiting on purpose. Press Skip to cancel it, then start the program again.
Systems a technician may investigate.
These parts relate to the symptom. The observation alone does not prove that any one has failed.
If the display adds a code.
Keep the exact message.
This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.
See the research statusRead the related care guide.

Dryer not drying? Start with the filters.
When an ASKO heat-pump dryer stops heating or drying, the usual causes are clogged filters, a room that is too warm, cold or cramped, the wrong program, or laundry that wasn't spun enough. Here's how to check each one.

Drying taking longer? Check both lint filters.
Clean the door lint filter after every load, and clean the lower lint filter, its foam filter and the housing at least every 10 cycles, brushing the heat exchanger fins gently if dust has built up.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if the drum still won’t turn after these checks. A belt, motor or control problem can’t be told apart from the outside, and ASKO leaves repairs to trained experts, so don’t take anything apart.
Arrange a diagnosticSources and model boundaries.
These references support the Dryer drum won’t turn guidance. Read the manual that matches your model.
- ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use
Use the instructions for your exact model. See how we research these pages.
Does every dryer have a condensate tank?
No. Only condenser and heat-pump dryers collect water in a tank. A vented dryer sends moist air outside, so skip that check if yours is vented.
Why did my dryer stop partway through a cycle?
The same causes apply mid-cycle: the door opened, the tank filled or the power dropped. After a power cut, the display tells you to press Start/Pause to carry on.
Why does my dryer door pop open during drying?
There’s too much laundry in the drum pushing on the door. Take some out and start again.
What should I tell the technician?
Whether the drum hums without turning or stays silent, any message on the display, and whether it stopped at the start or partway through.
Code / symptom / part / service
Connect the message to the next step.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.
Door lock
The door lock holds the door shut while a cycle runs. If it doesn’t click into place, the ASKO DBI786 dishwasher won’t start, and the WM86L washer shows E2, a door lock error.
Dryer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.
