Start from the symptom
ASKO dryer making loud noises.
Some sounds are normal on a heat-pump dryer like the ASKO T5HXL: compressor hum, pumping as water moves to the tank, and buttons or zippers rattling. Loud rattling or shaking is different. Check that the dryer stands level, touches nothing nearby and has its load spread out.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Match the sound to the normal list
Buzzing, humming, pumping, clicking and a whoosh of water during automatic heat-exchanger cleaning are all normal. A slight rumble after a long break should fade as the dryer runs.
- 2
Check what the dryer touches
Look for a wall, cabinet or basket touching the dryer, and keep the air intake on the front clear. Don’t pull out a stacked or built-in dryer on your own.
- 3
Spread out the load
Stop the drum and untangle sheets and towels. Before the next load, close zippers and fasten buttons.
Systems a technician may investigate.
The glossary pictures show each part type with dishwasher examples. ASKO’s T5HXL dryers heat the air with a heat pump rather than an element, so the technician works out any replacement part from your exact model.
If the display adds a code.
Keep the exact message.
This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.
See the research statusRead the related care guide.

Dryer not drying? Start with the filters.
When an ASKO heat-pump dryer stops heating or drying, the usual causes are clogged filters, a room that is too warm, cold or cramped, the wrong program, or laundry that wasn't spun enough. Here's how to check each one.

Drying taking longer? Check both lint filters.
Clean the door lint filter after every load, and clean the lower lint filter, its foam filter and the housing at least every 10 cycles, brushing the heat exchanger fins gently if dust has built up.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if loud rattling or strong vibration continues after you’ve checked the footing, clearances and load, or if a new noise keeps getting worse.
Arrange a diagnosticSources and model boundaries.
These references support the Dryer making loud noises guidance. Read the manual that matches your model.
- ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use
Use the instructions for your exact model. See how we research these pages.
Why does my dryer rumble the first time I use it after a vacation?
After a long rest, the drum can leave temporary dimples on its rubber rollers. ASKO says the rumbling goes away on its own as the dryer runs.
Is clicking from my dryer normal?
On the T5HXL, yes. The clicking marks the start of the automatic heat exchanger cleaning cycle, and you may hear water whooshing as it runs.
Can uneven feet make a dryer loud?
Yes. ASKO says to check that the dryer stands on a stable, level surface with the feet adjusted correctly, and notes that poor leveling causes vibration and loud running. If the dryer rocks when you press a corner, the feet need adjusting.
What should I tell the technician?
When the noise starts, what it sounds like and whether it changes with the load. If the dryer is stacked on a washer, say so.
Code / symptom / part / service
Connect the message to the next step.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.
Dryer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.
