Start from the symptom

ASKO cooktop zone won’t heat.

Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.

Last reviewed

Steel saucepan of cold water on an induction cooktop zone with a red indicator lit, no bubbles in the water, other zones dark
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Start with safe observations.

Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.

  1. 1

    Test the pan with a magnet

    Hold a fridge magnet to the base. The manual counts a pan as suitable when the base is firmly attracted. Copper, aluminum, earthenware, porcelain and ordinary stainless steel are on its unsuitable list.

  2. 2

    Match the pan to the zone

    A pan that’s too small won’t switch the zone on. The manual sets a minimum base for each zone, from 110 mm (about 4 3/8 in) on the smallest to 145 mm (about 5 3/4 in) on the rest.

  3. 3

    Look for Loc or a pause

    If the display shows Loc, the child lock is on: switch the cooktop on and touch the on/off key for 2 seconds to release it. A paused cooktop holds every zone at setting 1 until you touch pause/start again.

Systems a technician may investigate.

Each glossary photo shows a dishwasher version of the part. An induction cooktop heats differently from a classic element, so the technician identifies any replacement from your exact model.

If the display adds a code.

Keep the exact message.

This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.

See the research status

When observation becomes a service request.

Leave internal testing to a technician.

Book a visit if the zone stays cold even though the magnet grips the pan and its base is big enough, or if a code appears. If you spot a crack in the glass, however small, turn the cooktop off and cut its power before anything else.

Arrange a diagnostic

Sources and model boundaries.

These references support the Cooktop zone won’t heat guidance. Read the manual that matches your model.

  • Induction hob HI5320F, HI5632F, HI5642F, HI5643F, HI5842F, HI5952F, HI5954F operating instructions

Use the instructions for your exact model. See how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
Why did a zone switch off in the middle of cooking?

Look at the residual heat indicator. If it’s lit, the zone overheated, and the manual says you can carry on once the cooktop has cooled. If you heard a signal instead, a zone timer has run out.

Why does the power drop on its own?

That’s the overheating protection. When a zone gets very hot, the cooktop lowers its power, and if that isn’t enough it switches the zone off. Boost also falls back to setting 12 after 10 minutes.

Why does one zone work and another doesn’t?

Try the same pan on both zones. If it heats on one and not the other, the pan is fine and the cold zone needs a technician. If it fails on both, look at the pan or the settings first.

What should I tell the technician?

Which zone, the pan you used, the power level, and whether the zone fails every time or only now and then. Include the cooktop’s model number.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.