Before work starts
You agree the price with the technician before any work starts. Exact cost is confirmed after an on-site diagnostic.
Independent appliance repair
We repair ASKO cooktops when a zone won’t heat or the display shows an error. Tell us which zone is affected, whether the others still work and any code you see.


Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.

Note the exact code, upper and lower case included. On ASKO HI5 induction cooktops, F0 to F7 point to the generator and Fc01, FC04, FC08, FC10 or FH to the controls: cut the power for 10 seconds, then reconnect. Fc alone means overheating, so let it cool. Book if a code stays.
This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.
See the research statusEach glossary photo shows a dishwasher version of the part. An induction cooktop heats differently from a classic element, so the technician identifies any replacement from your exact model.
How a visit works.
Thoughtful care, with you in the loop.

Choose your appliance and describe the issue. We’ll confirm the visit details.

The technician checks the appliance and agrees the price with you before work starts.

Once the repair is complete, the technician checks the work and explains what was done.
Check whether one zone or several won’t heat, and which setting you chose.
Take a photo of any code or flashing symbol. Cooktop codes are not the same as dishwasher or oven codes, so we read them against your model.
Let the surface cool, take the pans off and wipe the glass so the technician can test each zone.
Book a visit if a zone stays dead with a suitable pan, or if an F code returns after you’ve disconnected the power for 10 seconds.
If the glass is cracked, switch the cooktop off and disconnect it at once. Don’t lift the cooktop out or open the electrical connection yourself.
Arrange a diagnosticYou agree the price with the technician before any work starts. Exact cost is confirmed after an on-site diagnostic.
Repairs covered by the manufacturer’s warranty go through ASKO itself. We give a warranty on our workmanship.
On ASKO HI5 induction cooktops, a flashing zone display after you switch on means the pan isn’t suitable for induction or is less than 12 cm (about 4 3/4 in) across. Test the pan with a magnet: the base should be firmly attracted.
On the HI5 models, codes F0 to F7 point to the generator, and several FC codes to the control panel. Disconnect the power, wait 10 seconds and reconnect. If the code stays, book a technician.
The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. Knowing which zone fails and any code on the display helps us plan the visit.
Repairs covered by the manufacturer's warranty go through ASKO itself. We give a warranty on our workmanship. If you’re not sure which applies, have your purchase date ready when you call.
Yes, OEM parts are available on order. Cooktop parts depend on the exact model, so the technician confirms the part after testing.
Code / symptom / part / service
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.
A heating element turns electricity into heat. It warms the wash water in a dishwasher or washer and heats the cavity of an oven. A heating error tells you the heat isn’t right; it doesn’t prove the element itself has failed.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.