Start from the symptom
ASKO washer leaking water.
Stop the washer, switch it off and unplug it, then find where the water starts. The WM86L manual points to the inlet and drain hoses, the pump filter, the door seal, and too much detergent, which makes foam that can spill out.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Stop and cut the power
Stop the program and switch the washer off. Unplug it only if the plug and outlet are dry, and close the water tap if you can reach it safely.
- 2
Trace the water
Note where the puddle starts and when it appeared: filling, washing, draining or spinning. Check the hose connections at the back and the pump filter cover at the front for drips.
- 3
Check the detergent dose
Foam around the door after a wash usually means too much detergent. Go back to the recommended amount for the next load.
Systems a technician may investigate.
These parts relate to the symptom. The observation alone does not prove that any one has failed.
Read the related care guide.

Washer won't spin? Check the load first.
An ASKO washer that won't spin may have an unbalanced load, a spin setting turned off, or water that can't drain past a clogged pump filter. Here's how to check each one and when to call a technician.

Full load, half load or quarter? Pick the right washer program.
On the ASKO WM86L, use Normal Cotton for everyday cotton loads up to a full drum. Most special programs take half a load, and Wool/Hand wash, Time, Steam Refresh and a few others take a quarter. The maximum weight is printed on the washer's rating plate.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if water keeps appearing after these checks, if the display shows a leak or overflow error, or if you can’t stop the water. Don’t run another wash just to watch it leak.
Arrange a diagnosticSources and model boundaries.
These references support the Washer leaking water guidance. Read the manual that matches your model.
- WM86L washing machine instructions
Use the instructions for your exact model. See how we research these pages.
Does my washer shut the water off by itself if it leaks?
Yes. The WM86L has a leak sensor in its base. If water collects there, the washer stops the wash, shuts off the supply, runs the pump and shows an error.
What does E9 mean on my washer?
E9 means the washer detected water in its base. ASKO says to switch it off and on and check the outside; if you find no leak you can keep using it, otherwise close the water valve and call for service.
Can I use my old hoses with a new washer?
No. ASKO says to use only the water supply hose supplied with the washer, never a used one.
What should I tell the technician?
Where the water was, when in the cycle it appeared, any code on the display, and whether the washer was moved or reinstalled recently.
Code / symptom / part / service
Connect the message to the next step.
E11
E11 means the water in your ASKO washer rose too high. If water is still coming in, close the water tap and call a technician. If the washer stopped and pumped the water out, restart it once.
Washer not spinning
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Water supply valve
Controls water entering the appliance from your home’s plumbing.
Washer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.
