Start from the symptom
ASKO washer door seal leaking.
Water at the door doesn’t always mean a bad seal. ASKO’s WM86L manual lists the door seal alongside the hoses, the pump filter and too much detergent foam as leak sources. Check the seal for trapped items or damage, and cut back on detergent.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Make it safe first
Switch the washer off and unplug it, but only if the plug and outlet are dry. If water has reached them, turn the power off at the breaker instead.
- 2
Look inside the seal
With the drum stopped, gently fold back the rubber seal and look for socks, coins or hair caught in it, and for tears or cracks. Don’t pull the seal off its mount.
- 3
Cut back on detergent
Too much detergent makes extra foam, and foam can push water out. Use the recommended amount for your load and water hardness.
Systems a technician may investigate.
These parts relate to the symptom. The observation alone does not prove that any one has failed.
Read the related care guide.

Washer won't spin? Check the load first.
An ASKO washer that won't spin may have an unbalanced load, a spin setting turned off, or water that can't drain past a clogged pump filter. Here's how to check each one and when to call a technician.

Full load, half load or quarter? Pick the right washer program.
On the ASKO WM86L, use Normal Cotton for everyday cotton loads up to a full drum. Most special programs take half a load, and Wool/Hand wash, Time, Steam Refresh and a few others take a quarter. The maximum weight is printed on the washer's rating plate.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if the seal is torn or cracked, if water keeps appearing at the door, or if you can’t keep the water contained.
Arrange a diagnosticSources and model boundaries.
These references support the Washer door seal leaking guidance. Read the manual that matches your model.
- WM86L washing machine instructions
Use the instructions for your exact model. See how we research these pages.
How do I keep the door seal in good shape?
Wipe the rubber seal after every wash and pick out anything caught in its folds. ASKO says this helps the seal last longer.
What does E11 mean on my washer?
E11 means the water in the drum went above the safe level. The washer stops and pumps it out; if it keeps adding water anyway, close the water tap and call for service.
Is it the seal or a hose?
Look at where the puddle starts. Water that begins at the front under the door points to the seal or to foam; water at the back points to the hoses. The pump filter at the bottom front is the other place to check.
Can I replace the door seal myself?
It’s a job for a technician. A seal that isn’t seated correctly will keep leaking, so book a visit rather than pulling it out.
Code / symptom / part / service
Connect the message to the next step.
E11
E11 means the water in your ASKO washer rose too high. If water is still coming in, close the water tap and call a technician. If the washer stopped and pumped the water out, restart it once.
Washer not spinning
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Door lock
The door lock holds the door shut while a cycle runs. If it doesn’t click into place, the ASKO DBI786 dishwasher won’t start, and the WM86L washer shows E2, a door lock error.
Washer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.
