Start from the symptom
ASKO cooktop showing an error.
Note the exact code, upper and lower case included. On ASKO HI5 induction cooktops, F0 to F7 point to the generator and Fc01, FC04, FC08, FC10 or FH to the controls: cut the power for 10 seconds, then reconnect. Fc alone means overheating, so let it cool. Book if a code stays.

Start with safe observations.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Photograph the display
Take a photo before you touch anything. Case matters on this cooktop: the HI5 manual lists Fc and FC as different codes.
- 2
Check the codes you can fix
F9 means poor air circulation, so make sure the vent openings under the cooktop are clear. FJ means the mains voltage is too low, which is a question for your power company.
- 3
Reset once for generator and control codes
For F0 to F7, FC, Fc01, FC04, FC08, FC10 or FH, disconnect the cooktop, count to 10 and restore the power. If the code doesn’t clear, stop and book.
Systems a technician may investigate.
Each glossary photo shows a dishwasher version of the part. An induction cooktop heats differently from a classic element, so the technician identifies any replacement from your exact model.
If the display adds a code.
Keep the exact message.
This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
Book a visit if a code stays after the 10-second power reset, or if it isn’t in the manual’s table. FC02 means the connection is wrong or the voltage is too high, so have the electrical connection checked before using the cooktop.
Arrange a diagnosticSources and model boundaries.
These references support the Cooktop showing an error guidance. Read the manual that matches your model.
- Induction hob HI5320F, HI5632F, HI5642F, HI5643F, HI5842F, HI5952F, HI5954F operating instructions
Use the instructions for your exact model. See how we research these pages.
Can I reset my cooktop by switching off the breaker?
For the generator and control panel codes, yes. The manual says to cut the power for 10 seconds before reconnecting. Write the code down first, because it may not come back, and book if it returns.
What does Fc mean on my ASKO cooktop?
On the HI5 models, Fc on its own means the cooktop overheated. Let it cool down, then start cooking again. If it happens often, mention it when you book.
Why does my cooktop show E7?
On the HI5 models, E7 after Wi-Fi setup means the cooktop couldn’t join your network. It isn’t a cooking problem: try the connection again and make sure your router accepts new devices.
What should I send when I book?
The photo of the display, the model number, and what you were doing when the message appeared: which zone, which power level and which pan.
Code / symptom / part / service
Connect the message to the next step.
Cooktop zone won’t heat
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.
Cooktop repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.

