Start from the symptom

ASKO dryer not heating.

On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.

Last reviewed

Hand pressing a gray terry towel inside the dryer drum to check for warmth, the dryer door standing open
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Start with safe observations.

Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.

  1. 1

    Clean both lint filters

    Clear the door filter, then pull out the lower filter and clean its foam insert and housing. On the ASKO T5HXL dryers the lower filter needs this at least every 10 cycles.

  2. 2

    Check the room

    These dryers are meant for a ventilated room between 50 and 77°F. Below freezing they may not run properly, and a cramped laundry space leaves too little air, which slows drying.

  3. 3

    Note the program and how the cycle ends

    Write down the program, how full the drum was and any message on the display. Make sure the program suits that fabric.

Systems a technician may investigate.

The glossary pictures show each part type with dishwasher examples. ASKO’s T5HXL dryers heat the air with a heat pump rather than an element, so the technician works out any replacement part from your exact model.

If the display adds a code.

Keep the exact message.

This appliance’s code meanings are not researched here. Use its model manual and send a photo of the display with your request.

See the research status

When observation becomes a service request.

Leave internal testing to a technician.

Book a visit if drying doesn’t recover after you’ve cleaned the filters and checked the room. Leave the heat pump, wiring and controls to a technician.

Arrange a diagnostic

Sources and model boundaries.

These references support the Dryer not heating guidance. Read the manual that matches your model.

  • ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use

Use the instructions for your exact model. See how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
Does my dryer need fresh air to work properly?

Yes. Keep the cool air intake on the front uncovered, and leave the clearances the manual gives around the dryer, or it can overheat. Open a door or window if the room is closed in.

What if the laundry is still damp when the program ends?

Run a Time program to finish it off. If it happens with every load, check that your washer spun the laundry at 800 rpm or faster first.

Will my dryer tell me when the filters are blocked?

It can. The T5HXL shows reminders such as “Clean lint filter” and “Clean lower lint filter” when you open the door. Treat them as part of the routine.

What should I tell the technician?

The model, the program, roughly how long a normal load takes now, and whether the filters were clean. Mention any message on the display.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.