What it means
F52 asks you to clean the coarse and fine filters. Newer ASKO manuals call it a water level error, but the fix starts in the same place: clean filters, then a test program.
ASKO dishwasher F52 / Drain
F52 asks you to clean the coarse and fine filters. Newer ASKO manuals call it a water level error, but the fix starts in the same place: clean filters, then a test program.
Also shown as Fault F52
F52 asks you to clean the coarse and fine filters. Newer ASKO manuals call it a water level error, but the fix starts in the same place: clean filters, then a test program.
Unplug the dishwasher, lift out the coarse and fine filters and rinse them until the mesh is clear.
F52 comes back even with freshly cleaned filters.
Your check-list / saved on this device

Unplug the dishwasher, lift out the coarse and fine filters and rinse them until the mesh is clear. Put them back so they sit flat.

Plug back in, press any button to clear F52 and run any dishwashing program. That shows whether the code has gone.

If clean filters don’t clear F52, book a technician to look at the water level problem.
Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The coarse filter catches the larger food scraps that can’t pass through the drain pump.
Read the definition
Component reference
The fine filter sits under the coarse filter and catches the smaller particles.
Read the definitionManufacturer document
ASKO / Gorenje Group
Document 843099en / pp. 28–29
Manufacturer document
ASKO / Gorenje Group
Document 879712en / pp. 38–39, 45
The DBI675 shows F52 as a reminder to clean the filters, with water level in brackets. The DBI776 and DBI786 call it a water level error. The first step is the same on all three: clean both filters.
No. ASKO’s overfill codes are F10 and F54. F52 is a water level error, and the manual’s fix is clean filters.
The DBI675 puts the instruction in words next to the code. The DBI786 uses a water level description. The job is the same on both.
Rinse them anyway and check they’re seated properly: the manual lists badly fitted filters as a cause of water staying in the tub. If F52 still shows after that, call.
Clean the filters first. If the code stays after a program with clean filters, stop and book a visit.
Code / symptom / part / service
F10 means the water in your dishwasher rose past the first overfill level. ASKO’s first step is to clear the drain pump. If F10 keeps coming back after that, book a technician.
The DBI786 manual traces water left above the filters to four things you can check yourself: clogged or loose filters, debris in the drain pump, a missing drain pump stop, and a kinked or blocked drain hose. Unplug the dishwasher before you start.
Catches larger pieces of food before they reach the drain system.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.