What it means
E11 means the water in your ASKO washer rose too high. If water is still coming in, close the water tap and call a technician. If the washer stopped and pumped the water out, restart it once.
ASKO washer E11 / Overflow
E11 means the water in your ASKO washer rose too high. If water is still coming in, close the water tap and call a technician. If the washer stopped and pumped the water out, restart it once.
Also shown as E11
E11 means the water in your ASKO washer rose too high. If water is still coming in, close the water tap and call a technician. If the washer stopped and pumped the water out, restart it once.
If the drum is overfull and the washer is still adding water, close the water tap now and book service.
The washer keeps adding water after E11 appears, or E11 comes back after a restart.
Your check-list / saved on this device

If the drum is overfull and the washer is still adding water, close the water tap now and book service. Keep away from the plug and outlet if there’s water on the floor.

When the washer detects an overflow, it stops the program and pumps the water out. Leave the door shut while that happens.

If water has stopped coming in and the drum has emptied, restart the program. If E11 comes back, stop and call a technician.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The water supply valve is the shutoff on the household pipe that feeds your dishwasher or washer.
Read the definition
Component reference
The washer drain pump pumps used water out of the drum and into your household drain.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Water overflow protection
The two E11 cases come from the WM86L instructions. ASKO washers from other series may handle overflow differently.
Watch and listen. If water is still running in while E11 is on, close the tap and call. If the washer is pumping out and nothing is coming in, restart once it’s done.
Yes. If the water rises above normal, it shuts off the supply and starts pumping out. If the level doesn’t drop within 60 seconds, the program stops.
Wait until the water has been pumped out. Forcing the door while there’s water in the drum can flood the floor.
No. E10 is a water level sensor error. E11 means the water actually went too high.
Code / symptom / part / service
E3 means your ASKO washer isn’t filling with water properly. Check that the water valve is open and the inlet hose isn’t kinked, then press OK to carry on. Call a technician if E3 returns.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Controls water entering the appliance from your home’s plumbing.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.