What it means
E3 means your ASKO washer isn’t filling with water properly. Check that the water valve is open and the inlet hose isn’t kinked, then press OK to carry on. Call a technician if E3 returns.
ASKO washer E3 / Water supply
E3 means your ASKO washer isn’t filling with water properly. Check that the water valve is open and the inlet hose isn’t kinked, then press OK to carry on. Call a technician if E3 returns.
Also shown as E3
E3 means your ASKO washer isn’t filling with water properly. Check that the water valve is open and the inlet hose isn’t kinked, then press OK to carry on. Call a technician if E3 returns.
Make sure the washer’s water supply valve is turned fully on.
E3 returns after you’ve checked the valve, the inlet hose and its filter, or you can’t check the pressure or hose height safely.
Your check-list / saved on this device

Make sure the washer’s water supply valve is turned fully on. If you see water leaking anywhere, turn it off and don’t restart.

Look along the inlet hose for kinks, crushing or a blockage. The hose has its own small filter; close the water valve before you unscrew the hose to clean it.

ASKO wants mains pressure between 0.1 and 1 MPa (1 to 10 bar), and the drain hose at the height shown in the installation section. Press OK to resume once that’s sorted. If E3 comes back, call a technician.
Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The water supply valve is the shutoff on the household pipe that feeds your dishwasher or washer.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Connection to water supply; Installing the drain hose
The E3 checklist is from the WM86L instructions. A washer from another ASKO series may word it differently.
An open valve is only the first check. A kinked inlet hose, a clogged inlet hose filter, low pressure or a drain hose at the wrong height can all trigger E3.
The WM86L manual asks for 0.1 to 1 MPa, which is 1 to 10 bar (roughly 15 to 145 psi).
Press OK and the washer picks the program up again. If E3 shows a second time, book a visit.
Yes, it’s on the manual’s E3 list. Close the water valve first, unscrew the hose, rinse the filter and reconnect the hose firmly before you open the valve again.
Code / symptom / part / service
E10 is a water level sensor error on ASKO WM86L washers. Unplug the washer, plug it back in and switch it on. If E10 stays, drain the washer, clean the pump filter and clean the wall trap.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Controls water entering the appliance from your home’s plumbing.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.