What it means
E10 is a water level sensor error on ASKO WM86L washers. Unplug the washer, plug it back in and switch it on. If E10 stays, drain the washer, clean the pump filter and clean the wall trap.
ASKO washer E10 / Water level
E10 is a water level sensor error on ASKO WM86L washers. Unplug the washer, plug it back in and switch it on. If E10 stays, drain the washer, clean the pump filter and clean the wall trap.
Also shown as E10
E10 is a water level sensor error on ASKO WM86L washers. Unplug the washer, plug it back in and switch it on. If E10 stays, drain the washer, clean the pump filter and clean the wall trap.
Pull the plug from the outlet, plug it back in and switch the washer on.
E10 is still there after a power reset, draining, a clean pump filter and a clean wall trap.
Your check-list / saved on this device

Pull the plug from the outlet, plug it back in and switch the washer on. Only touch the plug if it and the outlet are dry.

Empty the washer through the small drain hose into a shallow container, then take out the pump filter and rinse it. Clean the wall-mounted trap that the drain hose runs into as well.

If the code is back after the reset and the cleaning, book a diagnostic. Testing the level sensor is a technician’s job.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The pump filter catches coins, buttons, hair and other small objects before they reach the washer’s drain pump.
Read the definition
Component reference
The ASKO WM86L washer watches the water in the drum with a level sensor, and E10 is its error.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Cleaning the filter; Installing the drain hose
E10 and E10.1 share this entry in the WM86L instructions. Check your own manual if your washer is from a different series.
It’s how the manual groups three cleaning jobs: drain the washer, clean the pump filter and clean the wall-mounted trap.
Yes. Run the water out through the small drain hose into a large shallow container first, or it will pour out when the filter comes loose.
The manual lists E10 and E10.1 together under the water level sensor error, with the same steps.
The manual includes cleaning the wall-mounted trap in the E10 steps, so a clogged trap is worth ruling out before you call.
Code / symptom / part / service
E7 means your ASKO washer couldn’t drain. Clean the pump filter, check the drain hose for kinks or clogs, and make sure the household drain is clear. Too much detergent can cause it too.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The ASKO WM86L washer watches the water in the drum with a level sensor, and E10 is its error. Unplug the washer, plug it back in and switch it on. If E10 returns, drain the washer, clean its pump filter and the wall-mounted trap, and call a technician if it stays.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.