What it means
E7 means your ASKO washer couldn’t drain. Clean the pump filter, check the drain hose for kinks or clogs, and make sure the household drain is clear. Too much detergent can cause it too.
ASKO washer E7 / Drain
E7 means your ASKO washer couldn’t drain. Clean the pump filter, check the drain hose for kinks or clogs, and make sure the household drain is clear. Too much detergent can cause it too.
Also shown as E7
E7 means your ASKO washer couldn’t drain. Clean the pump filter, check the drain hose for kinks or clogs, and make sure the household drain is clear. Too much detergent can cause it too.
Run the Drain program if it works, then unplug the washer.
E7 returns after you’ve cleaned the pump filter and checked the hose, the drain and the detergent dose.
Your check-list / saved on this device

Run the Drain program if it works, then unplug the washer. Release the small drain hose next to the filter, hold it over a large shallow container and open its cap.

Turn the filter counter-clockwise and pull it out. Rinse it, clear anything caught in the housing and on the rotor, then refit it firmly and cap the small hose.

Look for kinks or a clog in the drain hose, and check that the household drain isn’t backed up. The hose end must sit between the minimum and maximum heights given in the installation section.

Press Exit to carry on. If E7 comes back, book a technician instead of restarting over and over.
Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The pump filter catches coins, buttons, hair and other small objects before they reach the washer’s drain pump.
Read the definition
Component reference
The washer drain pump pumps used water out of the drum and into your household drain.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Cleaning the filter; Installing the drain hose
The E7 checks are from the WM86L instructions. The same manual also lists E7.1, an alert that pumping has slowed, and E7.2 for too much detergent.
Yes. Extra detergent makes extra foam, and the manual lists it as an E7 cause. Go back to the dose on the detergent pack and see whether the code stops.
Use the opening tool kept at the front right of the dosing container. Drain the water through the small hose before you turn the filter, or it will pour out.
E7 stops the wash because the water didn’t drain. E7.1 is an alert that pumping has slowed, a prompt to clean the pump filter.
Then something inside the washer needs testing, such as the drain pump. Book a visit rather than running more programs.
Code / symptom / part / service
E10 is a water level sensor error on ASKO WM86L washers. Unplug the washer, plug it back in and switch it on. If E10 stays, drain the washer, clean the pump filter and clean the wall trap.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The washer drain pump pumps used water out of the drum and into your household drain. On the WM86L it sits behind the pump filter, so when E7 appears, a clogged filter is the first thing to check.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.