Inside the appliance
Washer pump filter. In plain English.
The pump filter catches coins, buttons, hair and other small objects before they reach the washer’s drain pump. ASKO recommends cleaning it once a month, and more often if you wash fleecy, very dirty or old laundry.

Where it fits.
Washer pump filter in the appliance
It is behind the drain filter cover on the front of the washer. On the WM86L, you open the cover with the tool stored at the front right of the dosing container.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Washer pump filter concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Drain the washer first
Start the Drain program, then pull the plug once it finishes. Release the small drain hose from its holder, hold the end over a large shallow container and open its cap.
- 2
Twist the filter out and rinse it
Turn the filter counterclockwise a little at a time and pull it out. Rinse it under running water, then clear the housing and impeller of anything left behind.
- 3
Seal it properly
Wipe the seal surface clean, turn the filter clockwise until it is tight, reattach the small hose and close the cover.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit if the filter won’t come out with gentle turning, the cover area leaks after cleaning, or E7 or E10 comes back with a clean filter.
Arrange a diagnosticSources and model boundaries.
These references support the Washer pump filter guidance. Read the manual that matches your model.
- WM86L washing machine instructions
Use the instructions for your exact model. See how we research these pages.
Why is there water in the filter of my new washer?
That’s expected. ASKO tests every washer before it ships, so a little water can remain in the drain pump filter. It doesn’t harm the machine.
What does E10 have to do with the pump filter?
E10 is a water level sensor error on the WM86L. After unplugging and restarting, the manual’s next step is to vent the washer by draining and cleaning the filter and cleaning the wall-mounted trap.
Should I clean the filter before storing the washer in the cold?
Yes. If the washer will sit somewhere that can drop below freezing, the WM86L manual asks you to clean the drain pump filter and empty the supply hose first.
My washer leaks at the front after I cleaned the filter. Why?
Check that the filter is turned clockwise all the way and that its seal surface was clean. The WM86L troubleshooting table names the pump filter, along with the door seal, as places to check for leaks.
Code / symptom / part / service
Connect the message to the next step.
E7
E7 means your ASKO washer couldn’t drain. Clean the pump filter, check the drain hose for kinks or clogs, and make sure the household drain is clear. Too much detergent can cause it too.
Washer not spinning
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Washer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.


