What it means
E23 means your ASKO washer’s door is closed but won’t unlock. Turn the washer off and back on. If the door stays locked, use the manual opening steps or call a technician.
ASKO washer E23 / Door
E23 means your ASKO washer’s door is closed but won’t unlock. Turn the washer off and back on. If the door stays locked, use the manual opening steps or call a technician.
Also shown as E23
E23 means your ASKO washer’s door is closed but won’t unlock. Turn the washer off and back on. If the door stays locked, use the manual opening steps or call a technician.
Forcing a locked door can damage the locking mechanism.
The door stays locked after a restart, or E23 keeps coming back.
Your check-list / saved on this device

Forcing a locked door can damage the locking mechanism. Leave it shut while E23 is on.

Turn the washer off, then back on, and give it a moment to release the lock.

If it’s still locked, unplug the washer and make sure the drum holds no water. Then follow the manual opening steps with a flat-blade screwdriver. Call a technician if E23 keeps coming back.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The door lock holds the door shut while a cycle runs.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Manual opening of washing machine door
E23 and E23.1 share this entry in the WM86L instructions. The manual door opening steps are in the same manual.
Unplug the washer and check the drum is empty of water. Insert a flat-blade screwdriver into the emergency slot on the right of the door latch, push gently and turn clockwise until it clicks.
Don’t open the door yet. Drain the washer through the pump filter’s small hose into a shallow container first, then try the manual opening.
Stop there and don’t use more force. Check again that the washer is unplugged and the drum is empty, then call a technician.
That’s normal after a manual opening. Close the door and follow the E2 reset: switch off, switch on and wait about 10 seconds.
Code / symptom / part / service
E2 is a door lock error on ASKO WM86L washers. First check that the door is fully shut. Then switch the washer off and on and wait about 10 seconds for the lock to reset.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The door lock holds the door shut while a cycle runs. If it doesn’t click into place, the ASKO DBI786 dishwasher won’t start, and the WM86L washer shows E2, a door lock error.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.