What it means
E22 means your ASKO washer’s door is closed but the lock couldn’t engage. Switch the washer off, switch it back on and restart the program. If E22 returns, call a technician.
ASKO washer E22 / Door
E22 means your ASKO washer’s door is closed but the lock couldn’t engage. Switch the washer off, switch it back on and restart the program. If E22 returns, call a technician.
Also shown as E22
E22 means your ASKO washer’s door is closed but the lock couldn’t engage. Switch the washer off, switch it back on and restart the program. If E22 returns, call a technician.
Check that the door is properly shut without pushing hard on the latch.
E22 shows again after an off-and-on restart.
Your check-list / saved on this device

Check that the door is properly shut without pushing hard on the latch. Take a photo of E22 for your records.

Turn the washer off, turn it back on and start the program again. Never tape, wedge or bypass the door lock.

Stop trying after a second E22 and book a technician. Lock adjustment, wiring and replacement are service jobs.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The door lock holds the door shut while a cycle runs.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Manual opening of washing machine door
E22 and E22.1 share this entry in the WM86L instructions. Washers from other ASKO series may use different door codes.
E2 is the general door lock error, which a door that isn’t fully shut can cause. E22 says the door is closed but still couldn’t be locked.
It won’t run until the door is locked. With E22 the lock didn’t engage, so the program can’t go ahead.
No. The restart is the only owner step the manual gives for E22. Anything beyond that needs a technician.
No. The manual lists E22 and E22.1 together, with the same restart step.
Code / symptom / part / service
E2 is a door lock error on ASKO WM86L washers. First check that the door is fully shut. Then switch the washer off and on and wait about 10 seconds for the lock to reset.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The door lock holds the door shut while a cycle runs. If it doesn’t click into place, the ASKO DBI786 dishwasher won’t start, and the WM86L washer shows E2, a door lock error.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.