What it means
E2 is a door lock error on ASKO WM86L washers. First check that the door is fully shut. Then switch the washer off and on and wait about 10 seconds for the lock to reset.
ASKO washer E2 / Door
E2 is a door lock error on ASKO WM86L washers. First check that the door is fully shut. Then switch the washer off and on and wait about 10 seconds for the lock to reset.
Also shown as E2
E2 is a door lock error on ASKO WM86L washers. First check that the door is fully shut. Then switch the washer off and on and wait about 10 seconds for the lock to reset.
Look for a sleeve or sock caught in the door edge.
E2 comes back after the lock reset, or you can’t get the door to close and latch.
Your check-list / saved on this device

Look for a sleeve or sock caught in the door edge. If the door isn’t fully closed, the washer pushes it back open, and the buttons won’t respond for about 10 seconds.

If the door is closed and E2 still shows, turn the washer off with the ON/OFF button, turn it back on and wait about 10 seconds. The lock resets by itself.

If the door won’t close at all, the manual shows how to release it with a flat-blade screwdriver, with the washer unplugged. If that feels unsafe, or E2 comes back, call a technician.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The door lock holds the door shut while a cycle runs.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display; Manual opening of washing machine door
These steps come from the door lock entry in the WM86L instructions. ASKO washers from other series may describe door codes differently.
That’s what it does when the door isn’t fully shut as it tries to lock. Close it firmly and wait about 10 seconds; the buttons won’t respond until then.
Unplug the washer and make sure the drum has no water in it. Then push a flat-blade screwdriver gently into the emergency slot on the right of the door latch and turn it clockwise until the door releases.
No. Never tape, wedge or force it. If the lock won’t reset with the steps above, call a technician.
They’re related. E22 means a closed door couldn’t be locked, and E23 means it couldn’t be unlocked. E2 is the general door lock error.
Code / symptom / part / service
E22 means your ASKO washer’s door is closed but the lock couldn’t engage. Switch the washer off, switch it back on and restart the program. If E22 returns, call a technician.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The door lock holds the door shut while a cycle runs. If it doesn’t click into place, the ASKO DBI786 dishwasher won’t start, and the WM86L washer shows E2, a door lock error.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.