Inside the appliance
Washer control panel and PMCU. In plain English.
The washer control panel on an ASKO WM86L talks to an internal PMCU module that runs the drum and cycles. The failure display lists E36 for a panel-to-PMCU communication loss. Power it down, then up again. A repeat E36 needs a technician, since no further owner step is printed.

Where it fits.
Washer control panel and PMCU in the appliance
The panel faces you on the washer. No PMCU position appears in the manual, so none is stated.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Washer control panel and PMCU concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Switch off and on
For E36 the entry asks for one power cycle with the on/off key.
- 2
Photograph the display
Record the code and the program that was running when it showed.
- 3
Keep the panel closed
A warning in the manual bars anyone from contacting the motor, pump or control unit while the washer is energized, since some internal parts are deliberately ungrounded.
- 4
Match E37 and E12 separately
E37 flags PMCU and UI software versions that do not match and goes to a technician. E12 covers the motor or its controller and starts with one program restart.
- 5
Do not replace anything first
Nothing should be swapped before a technician has checked the link.
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician when E36 or E37 returns after a power cycle.
Book a technician when E12 comes back after one restart.
Arrange a diagnosticSources and model boundaries.
These references support the Washer control panel and PMCU guidance. Read the manual that matches your model.
- WM86L washing machine instructions
Use the instructions for your exact model. See how we research these pages.
What does E36 mean on an ASKO washer?
The WM86L failure display describes E36 as lost communication between the UI and the PMCU. Power cycle the washer, and call a technician if it returns.
What is E37 on this washer?
E37 is listed for PMCU and UI software versions that are not compatible. The entry says to call a service technician.
What does E12 mean?
It reports a motor or motor control problem. Restart the program once, and call a technician if E12 reappears.
Is it safe to open the control area?
No. The warning covers the motor, pump and control unit while energized. Leave the cabinet closed.
Code / symptom / part / service
Connect the message to the next step.
E36
E36 means your ASKO washer’s control panel and its PMCU module aren’t communicating. Turn the washer off and back on. If E36 comes back, book a technician.
Washer not spinning
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
Washer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.


