ASKO washer E1 / Temperature sensing

ASKO washer
error E1

Washer / display reference

E1 is a temperature sensor error on ASKO WM86L washers. The manual says the incoming water may be too cold, so run the program again. If E1 shows a second time, call a technician.

Also shown as E1

Last reviewed

Washer / display reference
Meaning
E1 is a temperature sensor error on ASKO WM86L washers. The manual says the incoming water may be too cold, so run the program again. If E1 shows a second time, call a technician.
Who handles it
Technician
Related codes
Source
WM86L washing machine instructions

What ASKO washer E1 means.

What it means

E1 is a temperature sensor error on ASKO WM86L washers. The manual says the incoming water may be too cold, so run the program again. If E1 shows a second time, call a technician.

What you can safely check

Press and hold OK to see the error description on the display.

When to call a technician

E1 shows again after you’ve repeated the program.

Your check-list / saved on this device

Safe checks, in order.

0 of 3 checks done
  1. ASKO washer E1: White front-loading washer with its door open beside a laundry basket
    Illustration. Follow your model’s instructions.
    Before you begin

    Read the full message

    Press and hold OK to see the error description on the display. Snap a photo of it along with the program you chose.

  2. Black-gloved hands lifting a mesh filter out of a stainless dishwasher tub
    Illustration. Follow your model’s instructions.
    Check 2

    Run the wash again

    Switch the washer off and on, then restart the same program. ASKO links E1 to inlet water that’s too cold, so a second run may clear it.

  3. Technician in a navy jacket showing a checklist on a tablet to a customer
    Illustration. Follow your model’s instructions.
    Check 3

    Call if E1 comes back

    A second E1 needs a technician. Tell them whether it came back on the same program.

Still showing E1?

Share the model and the checks you tried. Start your request here.

Book a visit

Water heating and its sensor.

Conceptual Washer sectionHeaterTemperature sensorControl123

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Parts behind the message.

Black temperature sensor with a steel probe tip and mounting tabs

Component reference

NTC sensor

An NTC temperature sensor is a small probe whose electrical resistance drops as it warms up.

Read the definition

The manual behind the message.

Manufacturer document

WM86L washing machine instructions

ASKO / Gorenje Group

Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U

Document 946955en / Failure display

This meaning comes from the WM86L instructions. If your washer is from another series, check its own error table before acting.

Here to help

Good questions.
Clear answers.

Talk to our team
What does E1 mean on an ASKO washer?

The manual lists it as a temperature sensor failure. Its note under E1 reads “inlet water too cold”, so a cold supply can be behind it.

Can very cold tap water really cause E1?

The manual says so. In winter the incoming water can be colder than usual, and repeating the program is the step ASKO gives.

Can I replace the temperature sensor myself?

No. The sensor sits inside the washer, and the manual gives no owner steps for it. Leave the testing to a technician.

Is it safe to keep using the washer after E1?

If the repeat program finishes normally, carry on. If the code comes back, stop and book a visit.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.