What it means
E6 is a water heating error on ASKO WM86L washers. Restart the program once. If E6 comes back, the washer needs a technician to check the heating.
ASKO washer E6 / Heating
E6 is a water heating error on ASKO WM86L washers. Restart the program once. If E6 comes back, the washer needs a technician to check the heating.
Also shown as E6
E6 is a water heating error on ASKO WM86L washers. Restart the program once. If E6 comes back, the washer needs a technician to check the heating.
Note E6, the program and the temperature you picked before you clear it.
E6 shows again after a restart.
Your check-list / saved on this device

Note E6, the program and the temperature you picked before you clear it. Keep the washer’s panels closed.

Switch off, switch back on and start the program again. Only do this if nothing else looks wrong, such as a leak or a burning smell.

A second E6 means the heater circuit needs testing. That’s a job for a technician, not a home check.
Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Manufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display
The WM86L instructions are the source for this E6 meaning. An ASKO washer from another series has its own error table.
The washer flagged a problem heating the water. ASKO’s advice is one restart, then a service call if the code comes back.
No. It sits inside the washer, and testing it means working near mains power. Leave it to a technician.
They’re neighbors: E1 is the temperature sensor and E6 is water heating. Each gets one restart before you call.
Which program and temperature you used, and whether the code came back on the restart. A photo of the display helps.
Code / symptom / part / service
E1 is a temperature sensor error on ASKO WM86L washers. The manual says the incoming water may be too cold, so run the program again. If E1 shows a second time, call a technician.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
A heating element turns electricity into heat. It warms the wash water in a dishwasher or washer and heats the cavity of an oven. A heating error tells you the heat isn’t right; it doesn’t prove the element itself has failed.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.