Using your appliance

ASKO dishwasher programs: which one to choose for each load

On the ASKO DBI786, Normal is the everyday program for a full load of normally soiled dishes. Use Intensive for greasy pans, Eco to save energy, Crystal for fragile glass, Quick pro or Light for lightly soiled loads, and Sanitize for baby bottles and cutting boards.

Open dishwasher with glasses on top and pots on the lower rack
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Normal is the program the DBI786 manual recommends for daily, typical full loads. 1
  • Light and Quick pro are for slightly dried leftovers, never for burnt-on food. 1
  • Eco is the most energy-efficient program, and Green mode saves energy and water with Normal. 1
  • Auto needs five runs after installation before it adapts fully. 1
  • Programs can be hidden in Settings, so a missing program may simply be switched off. 1

Which ASKO dishwasher program should I use every day?#

Use Normal. On the ASKO DBI786, Normal is the program the manual recommends for daily, regular or typical use: a full load of normally soiled plates, serving dishes, cups and glasses. Switch to another program only when the load is unusual. 1

Every example in this guide comes from the user manual for the DBI786IXXLSSOF.U. Other ASKO dishwashers share many program names, but the list on your control panel can be shorter or different. If a name below does not appear on your display, check your own manual before you assume the machine is missing something. 1

The manual's basic rule is simple: choose a program to suit the type of dishes and how dirty they are. You scroll through the programs with the arrow buttons until the one you want is shown on the display. Then you add a mode or an option if you need one, and press Start. 1

What each DBI786 program is for#

The table lists every wash program in the DBI786 program chart, with its main-wash temperature and approximate time on a cold-water connection. Treat the times as a rough guide: the manual says they vary with incoming water temperature, room temperature, load size and the extras you add. 1

ProgramUse it forMain washApprox. time (cold water)
NormalEveryday full loads of normally soiled dishes131 °F (55 °C)2:05
AutoMixed loads; the machine senses soil and adjusts water and temperature122–149 °F (50–65 °C)2:30–3:40
EcoThe lowest energy use122 °F (50 °C)3:20
LightSlightly dried leftovers, not burnt food140 °F (60 °C)3:00
IntensiveGreasy pans, casserole and oven dishes158 °F (70 °C)3:15
Quick proA fast wash for slightly dried leftovers140 °F (60 °C)0:59
CrystalFragile crystal and glass113 °F (45 °C)1:45
TimeA wash that fits the time you setbelow 149 °F (65 °C)0:15–2:30
SanitizeBaby bottles and cutting boards158 °F (70 °C)1:30
PlasticDishwasher-safe plastic, with extra-long drying131 °F (55 °C)2:50
Lower halfPlates and cutlery in the lower basket only149 °F (65 °C)2:15
Upper halfCups and glasses in the upper basket only149 °F (65 °C)2:15

Source for every row: the program descriptions and program chart. 1

Three more entries sit in the same list but are not ordinary washes. Rinse and hold is a 7-minute rinse for dishes waiting until the machine is full. Self-cleaning cleans the tub, spray arms and spray pipes with no dishes inside. Anti-odor only runs the fan at intervals over 72 hours. 1

Top view of a dishwasher rack with plates standing and bowls on the sides
Match the program to what is actually in the racks. A load of only cups and glasses is the case Upper half was made for. 1

Which program is best for pots, pans and baked-on food?#

Choose Intensive. The DBI786 manual describes it as a high-temperature program for dissolving grease on heavily soiled pans, casserole dishes and oven dishes. If those items don't fill the machine, you can add plates and other dishes to the same load. 1

Don't reach for Light or Quick pro to save time on a roasting pan. The manual says plainly that both programs are not intended for burnt food, such as on oven dishes. They are made for leftovers that have only dried a little. 1

If the dishes are very dirty but you want to stay on a different program, add the Heat boost mode. It raises the temperature to dissolve grease, and the program runs longer and uses more energy and water. The troubleshooting table suggests exactly this when dishes come out dirty from an unsuitable program. 1

Using the Time program for heavy soil#

Time lets you decide how long the wash runs, and it adapts to that time or to a finish time you choose. The manual pairs each time band with a soil level, so pick the band that matches the load. 1

  1. 1

    Select Time#

    Scroll to the Time program with the arrow buttons. The display shows the program once it is selected. 1

  2. 2

    Set the length#

    Press the time button to choose the running time. Use 0:15–0:45 for lightly soiled dishes, 1:00–1:30 for normally soiled dishes and 2:00–2:30 for heavily soiled dishes. 1

  3. 3

    Start and close the door#

    Press Start until the display reads "Program started, Close door within 4 sec", then close the door firmly within four seconds. If you don't, the dishwasher will not start. 1

What is the most energy-efficient ASKO dishwasher program?#

Eco. The DBI786 manual names it the program that is most effective in terms of energy consumption. It runs at a lower temperature and takes longer, about 3 hours 20 minutes on a cold-water connection. 1

A longer program that uses less energy is normal. Eco makes up for the lower temperature with time. If you need the dishes sooner, Normal with the Green mode is the other energy-saving route the manual offers: Green uses less energy and water and is available with Normal. 1

The same chapter adds a few habits that save more than any single button. Scrape plates instead of rinsing them under the tap. Wait until the machine is full before you run it. Pick a lower-temperature program when the dishes are only lightly soiled. 1

Modes and options that change a program#

A program decides what the wash does. Modes and options adjust it. The DBI786 shows available modes dimly lit and active ones brighter, and the choices on offer change from program to program. 1

Mode or optionWhat it doesTrade-off
SpeedShortens the program timeUses more energy
GreenUses less energy and waterAvailable with Normal
NightLowers the noise levelThe program runs longer
Heat boostHigher temperature for very dirty dishesMore energy and water, longer time
UV cleanseSanitizes the final rinse water with UV light and heatMore energy, longer time
Automatic door openingOpens the door during drying for better resultsWait 5 minutes before closing it
Delayed startStarts the wash 1–24 hours laterNone listed

Source: Select program mode, Select option and Settings. 1

Quick pro gets faster with Speed: the manual says the combination shortens it to 39 minutes. Automatic door opening is already selected for some programs, and the manual calls it important for drying on Quick pro. Leave the door alone while it is open; blocking or closing it can damage the door lock mechanism. 1

There is one more setting worth knowing. Super rinse, in the Settings menu, adds two extra rinses to Normal, Light, Intensive, Quick pro, Sanitize, Plastic and both half programs. It makes the program longer and uses more energy and water. 1

Why does the time on my ASKO dishwasher keep changing?#

Because it's an estimate. Before you start, the DBI786 shows how long the program took last time. During the wash it updates the remaining time, which shifts with water temperature, load size and room temperature. 1

The first run of each program is the least accurate. The manual explains that the dishwasher is estimating the time on that first run, and from the second run on it uses the previous duration. A wash that finishes earlier or later than the first estimate is expected behavior. 1

Auto has its own learning period. When the machine is newly installed, Auto needs five runs before it is fully adapted and can give its best results. If you have just moved into a home with a new ASKO, give it those five runs before you judge it. 1

A program is missing from the list#

On the DBI786 you can hide programs you never use. Open Settings, go to Select programs and switch each one On or Off. Eco is the only program that cannot be hidden. Anti-odor only appears after you turn on Odor control in the same menu. 1

When the program isn't the problem#

If you have chosen the right program and the dishes still come out dirty, look at the rest of the machine. The DBI786 troubleshooting table lists blocked spray arms, the wrong detergent dose, clogged or badly fitted filters and a missing drain pump stop alongside program choice. 1

Start with the checks you can do yourself. Clean and refit the coarse filter and fine filter, make sure nothing blocks the spray arms, and run Intensive or a program with Heat boost. Our page on dishes that are not getting clean goes through those causes in order. 1

Our dishwasher service covers ASKO models like the DBI786. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. Repairs covered by the manufacturer's warranty go through ASKO itself. We give a warranty on our workmanship. You can book a visit when you are ready.

Sources#

  1. DBI786IXXLSSOF.U dishwasher user manualASKO / Gorenje Group · Document 879712en · pp. 11, 20–27, 31–33, 42

Here to help

Good questions.
Clear answers.

Talk to our team
A program I read about is missing from my dishwasher's display. Is something wrong?

Probably not. On the DBI786, programs can be shown or hidden from the Settings menu under Select programs. Only Eco cannot be hidden. Check that list before assuming anything is broken. See source 1, page 31.

Why is Anti-odor not in my program list?

On the DBI786, Anti-odor only appears after you switch on Odor control in the Settings menu. It runs the fan at intervals for up to 72 hours and does not wash. See source 1, pages 23, 27 and 33.

Can I use a dishwasher tablet with Quick pro?

The DBI786 manual does not recommend tablets for programs shorter than 75 minutes. Quick pro takes about 59 minutes, so use powder or gel instead. See source 1, pages 20 and 27.

Is Eco the fastest way to save money on a small load?

Eco is the most energy-efficient program on the DBI786, but it is also one of the longest at about 3 hours 20 minutes on cold water. The manual's advice is to run full loads and use lower temperatures for lightly soiled dishes. See source 1, pages 11 and 27.

Does Auto give good results straight after installation?

The DBI786 manual says Auto needs to run five times before it has fully adapted and can give its best results. See source 1, page 21.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.