What it means
E12 is a motor or motor control error on ASKO WM86L washers. Restart the program once. If E12 comes back, book a technician; the code doesn’t say whether the motor or its control is the problem.
ASKO washer E12 / Motor
E12 is a motor or motor control error on ASKO WM86L washers. Restart the program once. If E12 comes back, book a technician; the code doesn’t say whether the motor or its control is the problem.
Also shown as E12
E12 is a motor or motor control error on ASKO WM86L washers. Restart the program once. If E12 comes back, book a technician; the code doesn’t say whether the motor or its control is the problem.
Wait until the drum has stopped turning before you go near the door.
E12 comes back after one restart.
Your check-list / saved on this device

Wait until the drum has stopped turning before you go near the door. Note E12 and the program you were running.

Switch the washer off and on and start the program again. Leave the wiring and the control board alone.

A second E12 needs a technician to test the motor and its control. Keep the washer assembled until then.

Component reference
The washer control panel on an ASKO WM86L talks to an internal PMCU module that runs the drum and cycles.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display
This E12 meaning is in the WM86L instructions. Washers from older ASKO series may number their motor errors differently.
No. The manual has a separate code for that, E13, which asks you to spread the laundry out. E12 is about the motor or its control.
Try one restart. If the code comes back, stop using the washer and book a visit.
Not necessarily. E12 can come from the motor or from the control that runs it, and only testing tells them apart.
Both are electronic, but they’re different. E36 means the control panel and the PMCU lost contact; E12 is the motor or its control. Each starts with a restart.
Code / symptom / part / service
E36 means your ASKO washer’s control panel and its PMCU module aren’t communicating. Turn the washer off and back on. If E36 comes back, book a technician.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The washer control panel on an ASKO WM86L talks to an internal PMCU module that runs the drum and cycles. The failure display lists E36 for a panel-to-PMCU communication loss. Power it down, then up again. A repeat E36 needs a technician, since no further owner step is printed.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.