What it means
E36 means your ASKO washer’s control panel and its PMCU module aren’t communicating. Turn the washer off and back on. If E36 comes back, book a technician.
ASKO washer E36 / Electronics
E36 means your ASKO washer’s control panel and its PMCU module aren’t communicating. Turn the washer off and back on. If E36 comes back, book a technician.
Also shown as E36
E36 means your ASKO washer’s control panel and its PMCU module aren’t communicating. Turn the washer off and back on. If E36 comes back, book a technician.
Take a photo of E36 and note what the washer was doing when it appeared.
E36 comes back after you’ve switched the washer off and on.
Your check-list / saved on this device

Take a photo of E36 and note what the washer was doing when it appeared.

Use the ON/OFF button to switch the washer off, then back on. Keep the control panel closed.

A repeat E36 needs a technician to check the link between the panel and the PMCU. Nothing should be replaced before that diagnosis.

Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The washer control panel on an ASKO WM86L talks to an internal PMCU module that runs the drum and cycles.
Read the definitionManufacturer document
ASKO / Gorenje Group
Models: W5114RXLW, W5XLT.U, W5XLG.U, W5XLW.U
Document 946955en / Failure display
E36 is listed in the WM86L instructions. An ASKO oven or dishwasher showing a similar number means something else.
That’s how the manual names E36. UI is the user interface, the panel you press. The PMCU is the control module it talks to, and E36 means the two lost contact.
If it runs normally after the restart, yes. If E36 comes back, stop and book a visit.
Not necessarily. The code says the parts lost contact, not that either one failed. A technician tests the connection first.
No. This meaning belongs to the WM86L washer table, and codes don’t carry over between appliance types.
Code / symptom / part / service
E12 is a motor or motor control error on ASKO WM86L washers. Restart the program once. If E12 comes back, book a technician; the code doesn’t say whether the motor or its control is the problem.
Check the spin setting first: a program without spin, or Pump stop, ends the wash with wet laundry on purpose. If the setting is right, the load may be too lopsided to spin, or a blocked pump filter may be keeping water in the drum.
The washer control panel on an ASKO WM86L talks to an internal PMCU module that runs the drum and cycles. The failure display lists E36 for a panel-to-PMCU communication loss. Power it down, then up again. A repeat E36 needs a technician, since no further owner step is printed.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.