What it means
F12 means your dishwasher isn’t getting enough water. Make sure its water supply valve is fully open, then press any button and restart the program. If F12 returns with the valve open, book a technician.
ASKO dishwasher F12 / Water supply
F12 means your dishwasher isn’t getting enough water. Make sure its water supply valve is fully open, then press any button and restart the program. If F12 returns with the valve open, book a technician.
Also shown as Fault F12
F12 means your dishwasher isn’t getting enough water. Make sure its water supply valve is fully open, then press any button and restart the program. If F12 returns with the valve open, book a technician.
Find the dishwasher’s water supply valve and turn it all the way open.
F12 keeps coming back even though the supply valve is fully open.
Your check-list / saved on this device

Find the dishwasher’s water supply valve and turn it all the way open. ASKO asks for water pressure between 4.2 and 140 psi.

Press any button to clear F12, then start the program again. Listen for water flowing in as the program begins.

If the valve is open and F12 still comes back, stop restarting. A technician can check the inlet and the pressure reaching the dishwasher.
Schematic. Layouts vary by model. Select an outlined part to see its photo and the matching check.

Component reference
The water supply valve is the shutoff on the household pipe that feeds your dishwasher or washer.
Read the definitionManufacturer document
ASKO / Gorenje Group
Document 879712en / p. 39
Manufacturer document
ASKO / Gorenje Group
Document 843099en / p. 29
The DBI675, DBI776 and DBI786 all use F12 this way. Their manuals list F67 as a second inlet code with the same first check.
Yes. The manual sets the working range at 4.2 to 140 psi (0.03 to 1.0 MPa). If other taps in the house are weak too, the problem may be the supply rather than the dishwasher.
F67 is a second water inlet code. The DBI786 and DBI675 manuals give it the same first step as F12: check that the supply valve is on.
Press any button on the panel. Then restart the program; if water flows in and the wash carries on, you’re done.
No. Nothing is leaking; the dishwasher simply can’t fill. It won’t wash until it gets water, though, so sort out the supply before the next load.
Code / symptom / part / service
Turn off your dishwasher’s water supply now. F40 means the inlet valve is letting water in when it should be shut. Keep the water off and call a technician.
The DBI786 manual traces water left above the filters to four things you can check yourself: clogged or loose filters, debris in the drain pump, a missing drain pump stop, and a kinked or blocked drain hose. Unplug the dishwasher before you start.
Controls water entering the appliance from your home’s plumbing.
Arrange a model-specific diagnostic at the appliance.
Office details and the access information to include.