Inside the appliance
Dryer lower lint filter. In plain English.
The lower lint filter on an ASKO heat-pump dryer catches lint ahead of the heat exchanger. The T5HXL manual asks you to clean it, its foam part and the mesh housing after every 10 drying cycles, or after 30 with the self-cleaning system.

Where it fits.
Dryer lower lint filter in the appliance
Beneath the outer cover on the dryer front, down low, in a housing with a handle.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Dryer lower lint filter concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.

Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.

Dryer takes too long
Before you book, check three things: that the washer spun the clothes well, that the load suits the program you picked, and that both lint filters are clean. Each one can stretch a drying cycle on an ASKO dryer.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Open the cover
Press inward in the middle of the lid to open the outer cover, and lay a cloth on the floor for drips.
- 2
Pull the filter out
Rotate the handle of the lower filter housing upward and pull the filter toward you, tilted slightly.
- 3
Clean the foam without water
The manual says to vacuum the foam part with a soft brush attachment and not to rinse it under water. Let a damp foam dry first.
- 4
Reseat it correctly
Tilt the filter back in with the handle open, close the handle, then the cover. If the filter is out of its slot, the heat exchanger can clog.
Cleaning or replacement?
Leave internal testing to a technician.
Drying takes much longer after the filter is clean.
The foam is torn or the housing is cracked.
The heat exchanger fins look bent.
Arrange a diagnosticSources and model boundaries.
These references support the Dryer lower lint filter guidance. Read the manual that matches your model.
- ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use
Use the instructions for your exact model. See how we research these pages.
How often should the lower lint filter be cleaned?
After every 10 drying cycles or whenever necessary, or after every 30 cycles with the self-cleaning system.
Can I rinse the foam filter?
No. The manual says not to rinse it under water, to avoid microplastics in the groundwater.
What if I never clean it?
The manual warns of longer drying, higher energy use, overheating and a higher fire risk.
Can I use the dryer without it?
No. The manual forbids running the dryer with the lint filter missing or damaged.
Code / symptom / part / service
Connect the message to the next step.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.
Dryer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.

