Inside the appliance
Dryer condensate tank. In plain English.
The condensate tank collects the water taken from the laundry in an ASKO heat-pump dryer. Empty it after every drying cycle. A tank that fills up pauses the program by itself, and the manual lists that among the reasons for a dryer that stops part-way.

Where it fits.
Dryer condensate tank in the appliance
In the front of the dryer, a tank that pulls out.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Dryer condensate tank concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.

Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.

Dryer takes too long
Before you book, check three things: that the washer spun the clothes well, that the load suits the program you picked, and that both lint filters are clean. Each one can stretch a drying cycle on an ASKO dryer.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Pull it out with both hands
Pull the tank out with both hands, then turn it upside down slowly over a sink.
- 2
Pour out the water
Discharge the water through the condensate drain opening and refit the tank.
- 3
Do not drink or add
The water is not drinkable. The manual says never to add chemicals or fragrances to the tank.
- 4
Restart the program
If the dryer halted part-way, empty the tank, shut the door and restart the program.
Cleaning or replacement?
Leave internal testing to a technician.
The dryer keeps pausing even though the tank is empty.
The tank leaks or will not seat.
Water pools under the dryer.
Arrange a diagnosticSources and model boundaries.
These references support the Dryer condensate tank guidance. Read the manual that matches your model.
- ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use
Use the instructions for your exact model. See how we research these pages.
How often must I empty the tank?
After each drying cycle, as the manual says.
Why did my dryer stop mid-cycle?
The troubleshooting table lists a full condensate tank among the reasons. Empty it and restart.
Can I drain the water to a pipe instead?
The manual mentions a setting for draining condensed water to the drain. With it on, the full-tank warning is not shown.
Can I reuse the water?
The manual says it is not drinkable but, if thoroughly filtered, can be used for ironing.
Code / symptom / part / service
Connect the message to the next step.
Dryer not heating
On an ASKO heat-pump dryer, check the lint filters first. When they clog, the dryer can switch its compressor off to avoid overheating, and drying slows right down. Clean both filters, let the dryer cool, then restart it.
Dryer repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.

