Inside the appliance
Cooktop induction generator. In plain English.
The generator is the electronics that drive a cooking zone. The ASKO induction hob manual lists error codes F0 to F7 and FC as a defective generator and asks you to disconnect from the mains for 10 seconds and reconnect. If the code stays, call a technician.

Where it fits.
Cooktop induction generator in the appliance
Under the glass of the induction hob; not an owner part.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Cooktop induction generator concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.

Cooktop zone won’t heat
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.

Cooktop showing an error
Note the exact code, upper and lower case included. On ASKO HI5 induction cooktops, F0 to F7 point to the generator and Fc01, FC04, FC08, FC10 or FH to the controls: cut the power for 10 seconds, then reconnect. Fc alone means overheating, so let it cool. Book if a code stays.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Note the code
Write down exactly which code shows, since the manual treats F0 to F7 and FC alike.
- 2
Disconnect for 10 seconds
Disconnect the hob from the mains, wait 10 seconds and reconnect.
- 3
Let it cool for Fc
Fc means the appliance overheated. Let it cool and cook again.
Cleaning or replacement?
Leave internal testing to a technician.
The code is back after you reset for 10 seconds.
FC02 shows; the manual says the connection or mains voltage is wrong.
Only one zone fails.
Arrange a diagnosticSources and model boundaries.
These references support the Cooktop induction generator guidance. Read the manual that matches your model.
- Induction hob HI5320F, HI5632F, HI5642F, HI5643F, HI5842F, HI5952F, HI5954F operating instructions
Use the instructions for your exact model. See how we research these pages.
What do F0 to F7 mean?
The manual lists them as a defective generator.
What is the first step?
Disconnect from the mains, wait 10 seconds and reconnect.
What does FC02 mean?
The appliance has been connected incorrectly or the mains voltage is too high. Have the connection changed.
What does FJ mean?
Mains voltage is too low. Contact your energy supplier.
Code / symptom / part / service
Connect the message to the next step.
Cooktop zone won’t heat
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.
Cooktop repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.

