Inside the appliance
Cooktop cooling fan. In plain English.
ASKO induction hobs have a cooling fan for the electronics. The manual says it can run for several minutes after you switch the hob off, and lists F9 as poor air circulation: keep the venting holes under the cooking plate open.

Where it fits.
Cooktop cooling fan in the appliance
Under the cooking plate of the induction hob, below the glass; the venting holes are in the cabinet underneath.
The picture illustrates the component type. It does not identify a compatible replacement for your model.
What changes when this system needs attention.
Cooktop cooling fan concerns can appear alongside a change in performance or a recurring code. Testing is needed before deciding whether the component is responsible.

Cooktop zone won’t heat
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.

Cooktop showing an error
Note the exact code, upper and lower case included. On ASKO HI5 induction cooktops, F0 to F7 point to the generator and Fc01, FC04, FC08, FC10 or FH to the controls: cut the power for 10 seconds, then reconnect. Fc alone means overheating, so let it cool. Book if a code stays.
Owner care, within the model instructions.
Switch off and unplug before owner-accessible checks. Watch for standing water and sharp debris. Do not touch a wet plug or electrical area, remove service panels, or go beyond your model’s owner instructions.
- 1
Let it run
A fan that runs on after cooking is normal operation, according to the manual.
- 2
Clear the vents
For F9, make sure the venting holes under the cooking plate are open and not blocked by stored items.
- 3
Listen for the buzz
During intense use the fan is activated and you may hear a buzzing sound that continues for several minutes.
Cleaning or replacement?
Leave internal testing to a technician.
F9 returns with the vents clear.
The fan runs for much longer than a few minutes.
The hob shuts down zones while the fan runs loudly.
Arrange a diagnosticSources and model boundaries.
These references support the Cooktop cooling fan guidance. Read the manual that matches your model.
- Induction hob HI5320F, HI5632F, HI5642F, HI5643F, HI5842F, HI5952F, HI5954F operating instructions
Use the instructions for your exact model. See how we research these pages.
Should the fan still be running after I switch off?
Yes. The manual lists the fan running on for several minutes after switch-off as normal operation.
What does F9 mean on an ASKO hob?
Air circulation is not good. Make sure the venting holes under the cooking plate are open.
Why is the fan loud?
During intense use the fan cools the electronics and can buzz.
Is F9 on a dishwasher the same thing?
No. Another appliance, another table. This one is for the hob only.
Code / symptom / part / service
Connect the message to the next step.
Cooktop zone won’t heat
Start with the pan. On ASKO HI5 induction cooktops, a zone only heats a pan whose base a magnet grips firmly. If the zone display keeps flashing after you switch it on, the pan isn’t suitable or is too small. If the pan is right and the zone stays cold, book a visit.
Cooktop repair
Arrange a model-specific diagnostic at the appliance.
Find your metro
Office details and the access information to include.

