Manual evidence
The DBI786 troubleshooting table covers F10, F11, F12, F40, F41, F45, F52, F54, F67 and F68. F7 does not appear. The DBI675 instructions report problems through status lights instead of numbered codes.
ASKO dishwasher F7 / Dishwasher
F7 is not part of the error table in the current ASKO DBI786 instructions, which list F10, F11, F12, F40, F41, F45, F52, F54, F67 and F68. Older ASKO models used different displays, so we do not assign F7 a meaning. Restart once; if F7 returns, a technician reads the error directly.
Switch off with the main switch, wait a minute and start a short program again.
If water stays above the filters, clean the coarse and fine filters, which is the first step the manual gives for drainage problems.
The model and serial are on the label on the edge of the door. Older models show codes differently, so the model matters.

F7 comes back after one restart, water stays in the tub, or the dishwasher will not start a program.
Source 1
ASKO / Gorenje Group / 879712en / Troubleshooting
Source 2
ASKO / Gorenje Group / Document 843099en / pp. 28–29
We can't confirm either. F7 is not in the error table we hold, and older ASKO models used other code sets.
F10 is in the table: water rose past the first overfill level, and the manual's first step is clearing the drain pump.
On the label along the edge of the door. Note both the model and the serial number; ASKO's documentation differs between generations.
We have no source that says so. A restart after power returns is still the sensible first step before booking a visit.