Manual evidence
Not listed. The DBI786 troubleshooting table covers F10, F11, F12, F40, F41, F45, F52, F54, F56, F67 and F68, and says any button clears the message. The DBI675 reports trouble through status lights, not numbered codes.
ASKO dishwasher F44 / Dishwasher
The ASKO dishwasher documents we hold do not print F44. The DBI786 table lists F10, F11, F12, F40, F41, F45, F52, F54, F56, F67 and F68, and the DBI675 uses status lights. We can't give F44 a meaning. A restart and a look at the filters are safe; if it keeps coming back, book a visit.
Use the main switch to power the machine down, wait a minute, then run a short program and see whether F44 comes back.
Open the door and check the tub. Water above the filters points to drainage, so clean the coarse and fine filters, the first step the DBI786 gives for outlet and level messages.
The label sits on the door edge. Note the model, the serial number and the display exactly as it reads before you book.
Should water spread across the floor, close the inlet valve first. Pull the plug only once the valve is closed and the floor around the plug is dry.

F44 keeps showing after a restart, the tub holds water, or the program halts before washing.
Source 1
ASKO / Gorenje Group / 879712en / Troubleshooting
Source 2
ASKO / Gorenje Group / Document 843099en / pp. 28–29
No. The table stops at F10, F11, F12, F40, F41, F45, F52, F54, F56, F67 and F68, so F44 has no printed meaning there.
Try one restart. If the program runs, drains and the code stays away, keep watching it. If the tub keeps holding water or F44 returns, leave it off and book a visit.
We can't say. The documents we hold do not tie F44 to any of them, and a guess could send you after the wrong part.
The model and serial from the door-edge label, the display as shown, and the point in the program where F44 appeared.