ASKO dishwasher F2 / Dishwasher

ASKO dishwasher
error F2

We have no ASKO source that defines F2. The DBI786 table starts at F10, and older ASKO dishwashers signal problems in other ways. One restart is a safe first step; if F2 stays, book a diagnostic with your model number ready.

Not decoded in the manuals we hold

Last reviewed

F2
Dishwasher
Manual evidence

What the manual says about ASKO dishwasher F2.

Manual evidence

Not listed. The DBI786 instructions list F10 to F68 only; the DBI675 instructions use status lights.

Safe first steps.

  1. 1

    Restart once

    Switch the dishwasher off at the main switch, wait about a minute, then choose a program again.

  2. 2

    Look at the water tap

    Make sure the water supply valve under the sink is fully open, which the manual checks first for water inlet problems.

  3. 3

    Find the model label

    Read the model on the door edge so the technician can match the right service data.

Write this down before you call.

Open dishwasher loaded with plates and glasses in a dark wood kitchen
  • Model and serial number
  • Full display text
  • When the message appears
  • Checks you have already tried

When to call.

F2 shows again after a restart or the program stops before washing.

Book a visit(844) 731-2978

The documents we checked.

Source 1

DBI786 operating instructions

ASKO / Gorenje Group / 879712en / Troubleshooting

Source 2

Asko DBI675IXXLS.U / DBI675THXXLS.U / DBI675PHXXLS.U Operating Instructions, Troubleshooting (PDF on the Gorenje Group document server, linked from us.asko.com)

ASKO / Gorenje Group / Document 843099en / pp. 28–29

Here to help

Good questions.
Clear answers.

Talk to our team
Why don't you list a meaning for F2?

Because none of the ASKO documents we checked prints one. A guessed meaning could send you after the wrong part.

Could F2 come from an older ASKO model?

Yes. ASKO changed its displays over the years, and the code sets differ between generations.

Should I unplug the dishwasher for F2?

Switching off at the main switch for about a minute is enough for a first restart. Unplug or use the breaker if you need to work near the unit.

What information speeds up a repair?

The model and serial from the door edge label, the full code as displayed and the step of the program where it stopped.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.