ASKO dryer F4 / Dryer

ASKO dryer
error F4

The current ASKO heat-pump dryer instructions show E0 to E9 and do not print F4. It likely comes from an older dryer whose table we have not verified, so we assign no meaning. Switch off for a minute, clean the lint filters, and book a visit should F4 reappear.

Not decoded in the manuals we hold

Last reviewed

F4
Dryer
Manual evidence

What the manual says about ASKO dryer F4.

Manual evidence

The T5HXL instructions show Error X on the display, with E0 control unit, E1.1 to E1.3 thermistor, E2 communication, E3 pump, E6 relay, E7 door, E8 button and E9 software versions. They say to turn the dryer off and on again. F4 is not listed.

Safe first steps.

  1. 1

    Switch off for a minute

    Turn the dryer off, wait one minute and switch it back on, which is what the manual says to do after any displayed error. Then start a short program and watch for F4.

  2. 2

    Clean the lint filters

    Pull out the door filter and, on heat-pump models, the lower filter, and clear the lint. Clogged filters slow drying and can raise the temperature inside.

  3. 3

    Write down model and code

    The rating label lists the model. Note it with the full code, because the older F-code dryers use a different table from the E-code ones.

Write this down before you call.

Stacked washer and dryer inside an oak laundry closet with towels above
  • Model and serial number
  • Full display text
  • When the message appears
  • Checks you have already tried

When to call.

F4 returns after the dryer has been off for a minute, or the dryer stops heating or tumbling.

Book a visit(844) 731-2978

The documents we checked.

Source 1

ASKO T5HXLW.U / T5HXLT.U / T5HXLG.U (TD86) heat-pump tumble dryer instructions for use

ASKO / Gorenje Group / Document 948040en, US edition (PDF) / pp. 60, 62–63

Here to help

Good questions.
Clear answers.

Talk to our team
Why does my ASKO dryer show F4 and not an E-code?

Most likely it is an older model. The current instructions list E0 to E9, and F4 is not among them.

Is F4 a heating problem?

We can't confirm that. Without a printed source we do not link F4 to a heater, a sensor or any other part.

Is the ASKO dishwasher F4 the same code?

No. Dishwashers and dryers use separate code sets, so a dishwasher F4 says nothing about a dryer.

Can I keep drying clothes with F4 showing?

After one restart, a short test cycle is fine if the dryer tumbles and heats normally. If F4 comes back or the drum stops, leave it off and book a visit.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.