Manual evidence
The T5HXL instructions show Error X on the display with E0 to E9 (for example E0 control unit failure, E3 pump error) and say to note the code, switch off, wait a minute and switch on again. F-codes are not listed.
ASKO dryer F1 / Dryer
ASKO's current T5HXL heat-pump dryer instructions use E-codes, E0 to E9, and do not list F1. F1 comes from older dryers whose code tables we have not verified, so we don't assign it a meaning. Check the filters and the power, then book a technician if F1 stays.
Manual evidence
The T5HXL instructions show Error X on the display with E0 to E9 (for example E0 control unit failure, E3 pump error) and say to note the code, switch off, wait a minute and switch on again. F-codes are not listed.
Turn the dryer off, wait one minute and switch it back on, as the current manual advises for any displayed error.
Clean the door filter and, on heat-pump models, the lower filter. Blocked filters cause many drying problems.
Read the model on the rating label and write down the full code. F-code dryers are an older generation.

F1 returns after the dryer has been off for a minute, or the dryer stops heating or tumbling.
Source 1
ASKO / Gorenje Group / Document 948040en, US edition (PDF) / pp. 60, 62–63
It is likely an older ASKO model. Current models use E-codes, and their table does not include F1.
We can't confirm it. Without a verified source we don't tie F1 to a part.
On the rating label, usually around the door opening. Note the full model; F-code dryers belong to an older generation.
If the code returns after a restart, stop using the dryer. A dryer that keeps stopping mid-cycle needs a diagnostic.