ASKO oven F85 / Oven

ASKO oven
error F85

The ASKO oven instructions we hold do not print F85. They cover one display, ERROR followed by a number, as a problem in the electronic module. A power reset is the safe first move; if F85 returns, the oven needs a technician, not a guess.

Not decoded in the manuals we hold

Last reviewed

F85
Oven
Manual evidence

What the manual says about ASKO oven F85.

Manual evidence

The troubleshooting entry covers a display reading ERROR XX, where XX is the error number, and calls for a few minutes without power, then setting the time, then a service technician if it persists. An F-prefixed F85 is not printed.

Safe first steps.

  1. 1

    Cut the power at the breaker

    Switch off the oven circuit at the breaker, not only at the control panel, and leave it off for several minutes so the module can reset fully.

  2. 2

    Restore power and set the time

    Turn the breaker back on. The manual wants the current time set before you use the oven again, so do that, then run a short bake test.

  3. 3

    Note when F85 appears

    Jot down whether it showed at switch-on, while heating or during a cleaning cycle. That timing helps the technician narrow F85 down on site.

Write this down before you call.

Built-in wall oven with its light on in a dark kitchen with warm wood
  • Model and serial number
  • Full display text
  • When the message appears
  • Checks you have already tried

When to call.

F85 reappears once power is restored, the oven stays cold, or the display sticks on the error.

Book a visit(844) 731-2978

The documents we checked.

Source 1

OT8687S / OT8687A oven instructions

ASKO / Gorenje Group / OT8687 / EN 33–34, Solving problems

Source 2

OCSM8487 oven instructions

ASKO / Gorenje Group / 794094en / EN 43, Solving problems

Here to help

Good questions.
Clear answers.

Talk to our team
Is F85 a door lock or a sensor problem?

We can't show that. The manuals tie F85 to no part, so we do not guess. The technician reads what the module stored, on site.

Does F85 mean the same as Err6?

The manuals do not separate them. Both fall under the general ERROR XX instruction, and only a diagnostic shows which one the module stored.

Why does the clock need setting after the reset?

Removing power clears the time. The manual lists setting it as part of the reset, so the oven can run timed programs again.

Can I use the oven while F85 is on the display?

If the reset clears it and the oven heats normally, yes. If F85 returns or the oven will not heat, stop using it and book a diagnostic.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.