ASKO oven Err6 / Oven

ASKO oven
error Err6

ASKO does not publish a separate meaning for Err6. The OT8687 and OCSM8487 oven instructions treat every ERROR number the same way: an error in the electronic module. Cut the power for a few minutes, reconnect, set the clock, and book a technician if Err6 comes back.

Not decoded in the manuals we hold

Last reviewed

Err6
Oven
Manual evidence

What the manual says about ASKO oven Err6.

Manual evidence

The display gives an error code, ERROR XX (XX is the number of the error). There is an error in the electronic module: disconnect the oven from the power supply for a few minutes, reconnect it and set the current time. Consult a service technician if the error persists.

Safe first steps.

  1. 1

    Switch the oven off at the breaker

    Turn off the circuit breaker for the oven, not just the controls, and leave it off for a few minutes so the electronic module fully resets.

  2. 2

    Restore power and set the clock

    Switch the breaker back on. The manual asks you to set the current time before you use the oven again.

  3. 3

    Note when Err6 appears

    If the code comes back, write down when it appears: at switch-on, while heating, during self-clean or after a power cut. That timing helps the technician.

Write this down before you call.

Built-in wall oven with its light on in a dark kitchen with warm wood
  • Model and serial number
  • Full display text
  • When the message appears
  • Checks you have already tried

When to call.

Err6 returns after the power reset, the oven will not heat, or the display stays locked on the error.

Book a visit(844) 731-2978

The documents we checked.

Source 1

OT8687S / OT8687A oven instructions

ASKO / Gorenje Group / OT8687 / EN 33–34, Solving problems

Source 2

OCSM8487 oven instructions

ASKO / Gorenje Group / 794094en / EN 43, Solving problems

Here to help

Good questions.
Clear answers.

Talk to our team
Is Err6 a door lock or sensor problem?

Not that we can show. ASKO's manuals do not tie Err6 to a part, so we do not guess. The technician reads the module's error memory on site.

Can I keep using the oven with Err6?

If the error clears after the power reset and the oven heats normally, you can. If it returns, stop using the oven and book a diagnostic.

What should I tell the technician about Err6?

The oven model from the rating plate, when Err6 first appeared, whether it cleared after the power reset, and anything that happened just before, such as a power cut or self-clean.

Will cutting the power erase my oven settings?

It clears the clock, which the manual asks you to set again. Saved programs depend on the model, so check them after the reset.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.