ASKO oven Err3 / Oven

ASKO oven
error Err3

ASKO gives Err3 no meaning of its own. The OT8687 and OCSM8487 instructions answer any numbered ERROR display the same way: a problem in the electronic module. Cut power for a few minutes, reconnect, set the clock, and book a visit if Err3 comes back.

Not decoded in the manuals we hold

Last reviewed

Err3
Oven
Manual evidence

What the manual says about ASKO oven Err3.

Manual evidence

The troubleshooting entry reads ERROR XX, where XX is the error number. It points to the electronic module: disconnect the oven from power for a few minutes, reconnect it, set the current time, and consult a service technician if the error stays. No separate line exists for Err3.

Safe first steps.

  1. 1

    Cut the power at the breaker

    Switch off the oven circuit at the breaker, not only at the control panel, and leave it off for several minutes so the module can reset fully.

  2. 2

    Restore power and set the time

    Turn the breaker back on. The manual wants the current time set before you use the oven again, so do that, then run a short bake test.

  3. 3

    Note when Err3 appears

    Jot down whether it showed at switch-on, while heating or during a cleaning cycle. That timing helps the technician narrow Err3 down on site.

Write this down before you call.

Built-in wall oven with its light on in a dark kitchen with warm wood
  • Model and serial number
  • Full display text
  • When the message appears
  • Checks you have already tried

When to call.

Err3 reappears once power is restored, the oven stays cold, or the display sticks on the error.

Book a visit(844) 731-2978

The documents we checked.

Source 1

OT8687S / OT8687A oven instructions

ASKO / Gorenje Group / OT8687 / EN 33–34, Solving problems

Source 2

OCSM8487 oven instructions

ASKO / Gorenje Group / 794094en / EN 43, Solving problems

Here to help

Good questions.
Clear answers.

Talk to our team
Is Err3 a door lock or a sensor problem?

We can't show that. The manuals tie Err3 to no part, so we do not guess. The technician reads what the module stored, on site.

Does Err3 mean the same as Err6?

The manuals do not separate them. Both fall under the general ERROR XX instruction, and only a diagnostic shows which one the module stored.

Why does the clock need setting after the reset?

Removing power clears the time. The manual lists setting it as part of the reset, so the oven can run timed programs again.

Can I use the oven while Err3 is on the display?

If the reset clears it and the oven heats normally, yes. If Err3 returns or the oven will not heat, stop using it and book a diagnostic.

Let’s take care of it.

Your home has a rhythm.
Let’s bring it back.