Asko Washer Error Code E7

If your Asko washer displays Error Code E7, it usually indicates a drainage issue—a problem with water not draining properly during the wash cycle. This error is a built-in safety feature designed to protect the appliance from potential water damage.

What Causes Asko Washer Error Code E7?

Error Code E7 typically points to a malfunction within the washer’s drainage system. Common causes include:

• A clogged drain filter

• A blocked or kinked drain hose

• A faulty drain pump

• Debris or lint buildup obstructing water flow

When the washer cannot evacuate water effectively, it triggers the E7 code to signal a problem that needs attention.

How to Fix Asko Washer Error Code E7 (DIY Guide)

1. Inspect the Drain Hose

Make sure the drain hose is not twisted, kinked, or clogged. Also, verify that the hose end is not sitting in standing water, which could restrict water flow.

2. Clean the Pump Filter

Access the pump filter, typically found at the bottom front of the washer. Open the filter cover, remove any lint, coins, or foreign objects, and rinse the filter thoroughly.

3. Check the Drain Filter

The drain filter might also be blocked with lint or hair. Cleaning it can often restore normal drainage and clear the E7 code.

4. Remove Clogs from the Drain Pipe

If accessible, inspect the drain pipe for any clogs. Clear any obstructions that might prevent water from flowing out properly.

5. Reset the Washer

Turn off the appliance and unplug it from the power outlet for 5–10 minutes. Reconnect and start a new wash cycle. In many cases, this will reset the E7 error.

When to Contact a Professional

If the E7 error remains after completing the above steps, the issue may be related to a damaged pump or an internal electrical fault. At that point, it’s best to contact Asko Appliance Support for expert diagnosis and repair.