Asko Washer Error Code E10

Error code E10 on your Asko washer usually points to a problem with the water level sensor—a vital component that ensures the correct amount of water is used during each wash cycle. When this sensor malfunctions, the washer may not fill properly or may stop mid-cycle, affecting cleaning performance.

This error can be triggered by a faulty sensor, clogged filters, or a malfunctioning water inlet valve. It’s important to fix the issue promptly to avoid further disruption to your laundry routine.

Common Causes of E10 Error in Asko Washers

• Faulty water level sensor that gives incorrect readings

• Clogged inlet filters reducing water flow

• Defective water inlet valve not allowing enough water in

• Electrical or control board glitch

How to Fix Asko Washer Error Code E10

1. Check Water Supply:
Make sure the water tap is fully open and there’s no interruption in supply. Inspect the inlet hose and valve for any damage or clogs.

2. Clean Inlet Filters:
Remove and rinse the mesh filters in the water inlet hose. Also inspect the washer’s internal filter if accessible.

3. Inspect the Water Level Sensor:
The pressure sensor might be dirty or faulty. Clean it gently to remove buildup. If the E10 error remains, the sensor might need replacing.

4. Reset the Washer:
Unplug the machine for a few minutes and restart. A reset often clears temporary electronic errors.

When to Call for Help

If you’ve tried all the above and the E10 error code still appears on your Asko washer, it’s time to call in the pros. At Asko Appliance Support, our skilled technicians can quickly diagnose and repair any Asko washer issue, including water level sensor problems. We offer reliable, same-day service to restore your washer’s performance.